How to Change the Air Filter on a Riding Mower

Do you know How to Change the Air Filter on a Riding Mower? It is highly recommended and required that your engine air filter should be cleaned or replaced every 50 operating hours.

How to Change the Air Filter on a Riding Mower
How to Change the Air Filter on a Riding Mower

CHECKOUT THIS POST >>> AMEXRewardCard.com Activation – Confirm and Set Up Your American Express Card

During dry or dusty conditions, changing your Air Filter should be done more frequently. The below instructions will guide you through the process of cleaning or replacing your air filter.

Steps To Change the Air Filter on a Riding Mower

INSTRUCTIONS:

Step 1:

Place the tractor on a flat leveled surface. Then turn off the mower, engage the parking brake and take out the ignition key. Allow the engine to cool down for some minutes. And then disconnect the spark plug ignition wire.

Step 2:

Take out the air cleaner cover from the engine. Then uninstall the air filter.

Step 3:

Clean the paper element filter by tapping it gently to remove the dust from it. If the element is so dirty, then you should replace it with a new one.

Step 4:

Wash the foam element with mild detergent and water, and allow to dry well. Note that you should never use gasoline or low flash-point solvents to clean the air cleaner elements. Immediately the foam element is completely dry, apply some drops of clean engine oil and squeeze out all the excess oil.

Step 5:

Reassemble the foam and paper elements together.

Step 6:

Reinstall the assembled air filter inside the housing section.

Step 7:

Reinstall the air cleaner cover and make sure it is secure.

Step 8:

Finally, reconnect the spark plug ignition wire.

YOU MAY LIKE >>> Reverse Mortgage Servicing Department – How to Get Started With ReverseDepartment

Leave a Reply

Your email address will not be published. Required fields are marked *